C-1205
C-1205 End-Matching System
• Chip-free End-Matching, Coping or Tenoning of either square or profiled parts without the need of a backup piece or chip braker.
• Two counter rotating spindles 1 ¼” Diameter, rotation at 7000 rpm’s
• 7.5 HP Motor, 3Phase 230/460 volt (wired 230 volt standard). Specify Voltage.
• Maximum Cutter Diameter 5” OD.
• Minimum Cutter Diameter 3 ½” OD.
• Maximum capacity of wood 2 ½” thick by 13 ½” wide.
• Unlimited Length of part.
• Minimum thickness 11/16” (can be modified to do ½”).
• Minimum Length of part 3”.
• Cycle time 6 to 10 seconds, (adjustable)
• Dust Outlet Diameter 5”.
• Tooling change take approximately two minutes or less.
• The C-1205 can also be used for Coping or Tenoning.
• Material hold clamp always parallel to work table.
• THK style rails for guidance of carriage stroke and hold down clamp.
• UL LISTED.
• Meets CSA Electrical Standards.
• Machines weight approx. 1167 lbs.
Contact us for Pricing information
Add On Options
- Modify thickness to ½”
- Aluminum sub-table for stacking tooling
- 5HP Single Phase Motor 230 volt
- Change Voltage to 460 volts
- *Remove all motors and electrical controls
Pictures are similar but may not be exact. Prices & Specifications subject to change without notice.
MADE IN THE USA
PATENTED
-
- Groove Cut For Flooring
-
- Tongue Cut For Flooring
-
- Spindle for C-1205
-
- Unlimited Part Length
-
- Unlimited Before
-
- Unlimited After
-
- Single Profile Before
-
- Single Profile After
-
- Square Stock After Process
-
- Double Profile Before
-
- Double Profile After
-
- Sub Table
